Can anyone help with supplying the lower "ashtray" cover that fits on a J type remote change unit. The thing that is held by two screws under the gear lever.
This subject comes up from time to time. It seems as though there is some demand for these but I imagine the tooling needed to make a batch is too expensive. This was the thread which appeared last October.
Many thanks everyone. I will have a go at making something up, I'm not sure tobacco tins are that easily available theses days but will keep an eye out.
I'm half wondering if an aluminium casting is the way to go, the pattern would only take an hour or two to make and they would only be about 310 to cast.
Many thanks everyone. I will have a go at making something up, I'm not sure tobacco tins are that easily available theses days but will keep an eye out.
I'm half wondering if an aluminium casting is the way to go, the pattern would only take an hour or two to make and they would only be about 310 to cast.